AMF Checkride Practice Test

These questions are part of the practice quiz. Start practicing

• What is the primary purpose of the AMF Checkride?
• What must the wingman do to maintain proper visual formation position behind lead?
• What is the best strategy if acceptable takeoff performance can only be achieved by using 0-degree flaps in windshear?
• Which of the following is subtracted from Basic Aircraft Weight to determine the overall weight?
• In a fifteen-second interval takeoff, when does the wingman release the brakes?
• In the context of the AMF Checkride, what is engine-out landing?
• What skill is crucial in handling a simulated engine failure?
• In the context of a position change, what maneuver does the wingman perform upon acknowledgment of the change?
• What is included in Basic Aircraft Weight?
• What is the angle the wing will turn from the base heading for 10 seconds?
• Why is both practical and theoretical knowledge critical for the checkride?
• What is the required minimum runway width for both aircraft to take off during a formation departure?
• What is the minimum separation for the legs of a standard anchor pattern?
• Why is knowledge of emergency equipment crucial for pilots?
• What is gain shear?
• What must happen when "terminate" is called during a flight?
• Is it true that formation rejoin may occur on top if conditions permit?
• How should pilots prepare for the oral portion of the AMF Checkride?
• What is the required altitude separation when executing a turning lost wingman maneuver?
• During a formation operation, how far above lead may the wingman fly at a minimum?
• What should pilots do in response to unexpected weather changes during the flight?
• What is the visual formation position for the wingman in terms of distance from lead?
• What flap setting is commonly used for low-level airdrop maneuvers?
• What is expected of a pilot during the preflight briefing before the AMF Checkride?
• What plays a key role in determining the spacing during a landing in formation?
• How do pilots illustrate risk management during the AMF Checkride?
• What should the wingman do if rejoin cannot be accomplished?
• What is the maximum distance a receiver should maintain behind the tanker in the precontact position?
• What factor is important in multi-engine climb performance?
• What distance should the wingman maintain for proper threshold spacing during the Tactical Overhead pattern?
• What equipment is essential for multiengine operations?
• What are the consequences of exceeding Vmc?
• What is the minimum altitude the lead aircraft will hold at during an orbit?
• True or False: "Terminate" can be called when safety is not a concern and learning objectives have been achieved.
• Which component is NOT considered when calculating Basic Aircraft Weight?
• Under which condition is a formation considered "Nonstandard"?
• Name a significant risk associated with multi-engine flying.
• Which factor can lead to disqualification during the AMF Checkride?
• Lead will initiate a climb at what KIAS?
• How can pilots ensure effective situational awareness during flight?
• What is the minimum airspeed for an airdrop configuration?
• What is the primary method for conducting a rendezvous during aerial refueling?
• In which situation might a receiver call for a breakaway?
• If a receiver cannot obtain clearance after air refueling, what should it do?
• How is checklist usage evaluated during the checkride?
• Who is responsible for making calls to clear the flightpath during a "knock-it-off"?
• What should lead maintain after a wingman calls "blind"?
• What should pilots do when flying through visible moisture?
• What altitude action is required during a "knock-it-off" call?
• Why is it necessary to understand Zero Fuel Weight for flight operations?
• Which aspect of aircraft design does LEMAC directly relate to?
• Where do arm measurements begin in an aircraft?
• What must the wingman confirm to complete the rejoin?
• What parameters define the holding pattern for a tanker orbiting at the ARCP?
• What information should the receiver transmit to the tanker during the initial 15-minute call?
• What does Basic Aircraft Weight include?
• What indicates that a position change has been directed by lead?
• What does MARSA require?
• How effective is radar at detecting volcanic dust?
• What is critical to demonstrate during an approach to land in a multi-engine aircraft?
• What does the ARCT represent in the context of aerial refueling?
• What is a characteristic of dynamic hydroplaning?
• What type of weather conditions is most challenging during the AMF Checkride?
• How is severe windshear identified?
• What happens to the wing once entering the route for airdrop maneuvers?
• What action is not permitted when the wingman is saturated with flight tasks?
• Why are post-flight assessments important for pilots?
• Which document outlines the prerequisites for the AMF Checkride?
• When in a cell position, how should a wingman respond if they lose sight of the lead?
• The weight of which items is categorized under Operating Weight?
• What should the tanker do after air refueling is completed?
• What are the three types of hydroplaning?
• How should a wingman react if they lose sight of the lead while wings level?
• What is the correct precontact position for a receiver aircraft?
• What should a pilot do if conditions allow for increased rotation speed in windshear?
• What is the role of the pilot in command (PIC) during the AMF Checkride?
• What is a crucial skill tested during the flight proficiency portion of the AMF Checkride?
• In what conditions might a go-around be necessary?
• What communication technique is emphasized during aviation checkrides?
• What characterizes loss shear?
• How can a pilot show proficiency in navigation tasks during the exam?
• Who has the authority to call for an overrun if it becomes imminent?
• What is the significance of simulated emergency exercises during the checkride?
• How can pilots minimize the risk of loss of control during multi-engine operations?
• What should the flight lead do when a wingman is lost?
• How can a pilot demonstrate knowledge of weight and balance concepts?
• How does a pilot demonstrate proficiency in situational awareness?
• How long before route entry should the lead aircraft take off at a minimum?
• Name one key area of focus during the oral examination.
• What happens to air refueling operations at the end of an air refueling track?
• Why is it essential to demonstrate knowledge of aircraft limitations?
• What should be assessed when understanding airspace classifications?
• What should a pilot do when assessing engine performance indicators?
• What is the significance of weight and balance calculations in multi-engine flying?
• What flap setting is recommended for takeoff in windshear conditions?
• Must the wing follow the lead into IMC conditions?
• During in-flight emergencies, what is a critical first step for a pilot?
• What should lead do if the wingman goes "blind" during a flight?
• When flying in offset position, what angle is considered optimal for the wingman relative to lead?
• What is the purpose of the ARCP?
• What is the standard speed for lead during climbs?
• How is an air refueling track scheduled?
• At what altitude must the receiver be positioned in relation to the tanker before crossing the IP?
• What type of weather is required for practicing lost wingman?
• What role do checklists serve in the AMF Checkride?
• Why is a thorough understanding of aircraft systems essential for the AMF Checkride?
• What should a pilot do before each maneuver during the flight portion?
• What should a pilot prioritize if they experience engine failure during takeoff?
• What is the acronym for the altitude to climb to after initiating a climb?
• If you must take off into windshear conditions, what should you consider?
• How is Operating Weight calculated?
• How should one manage brake overheating in desert operations?
• What is an anchor point in air refueling?
• What procedure is followed if VMC formation flight is not possible?
• What action must the receiver take if they cannot confirm 1,000 feet of separation from the tanker before crossing the IP?
• Why is real-time communication among crew members vital during flight operations?
• What specific regulations cover multi-engine aircraft operations?
• What happens if a pilot does not meet the flight hour requirement?
• Which method helps pilots track fuel efficiency during flight?
• How should a passenger briefing be conducted before the flight?
• Which knowledge area addresses aircraft approach and landing techniques?
• What does AMF stand for in the context of the Checkride?
• What is a likely effect of improper weight distribution in an aircraft?
• What is the maximum lateral separation allowed in a non-standard formation?
• What is a key evaluation focus during the AMF Checkride?
• Will the lead inform the wing of his/her climb airspeed?
• What is the primary purpose of calling "knock-it-off" during a flight?
• Which condition may indicate windshear?
• Describe the importance of the go/no-go decision.
• What do flight profiles in the AMF Checkride simulate?
• What flap setting is recommended for landing in windshear conditions?
• What should the tanker monitor throughout the refueling operation?
• If the wingman goes blind in IMC conditions, what is the appropriate action?
• What must the lead ensure during air refueling?
• When is the risk of icing on aircraft surfaces highest?
• What climb airspeed should the wing maintain while following the lead?
• What type of scheduling does the Scheduling Unit provide?
• During a formation Tactical Overhead pattern, when will the wingman begin the break?
• What should be initiated if any flight member does not respond correctly to a call?
• What is the main goal of the terminate call in the absence of safety issues?
• How many channels separate corresponding A/A TACANs?
• What key information should a pilot provide when communicating with ATC?
• What factor is crucial in ensuring effective crew resource management?
• What is the minimum altitude for a formation position change?
• What should pilots prioritize when dealing with an engine failure?
• How is the Leading Edge of Mean Aerodynamic Chord (LEMAC) defined?
• During the AMF Checkride, how is risk management evaluated?
• Which aircraft systems must pilots understand during the AMF Checkride?
• What direction should the holding turn be prebriefed for rejoin?
• What altitude difference is maintained when a wingman enters a holding pattern?
• When can lead use idle and speed brakes simultaneously?
• How should pilots manage adverse weather during the checkride?
• What is defined as the Wing Chord?
• What is the recommended preflight procedure before starting the AMF Checkride?
• What is the importance of understanding Vmc in aviation?
• Why is flight proficiency vital for AMF Checkride candidates?
• What is the primary purpose of the flight profile in the AMF Checkride?
• What is reference groundspeed?
• What must a pilot demonstrate to complete the AMF Checkride successfully?
• Can Air Refueling operations be conducted under VFR rules according to AP/1B?
• What does Zero Fuel Weight consist of?
• What does it mean if equipment is located at "Fuselage Station 120.0"?
• What is the typical squawk for the wing during an actual lost wingman scenario?
• What is the latest time the first radio contact between the tanker and receiver should occur?
• What is the optimum distance for the wingman in the offset position?
• In aircraft weight definitions, what does "unusable fuel" refer to?
• In what conditions is hydroplaning most likely to occur?
• Why should personnel stay clear of the main landing gear after landing?
• Why is crew resource management (CRM) crucial during flight?
• Which is NOT a condition that may indicate windshear?
• During the fifteen-second interval takeoff, what is the wingman required to do after releasing the brakes?
• What is the equation used to find the moment in aviation?
• When lead announces base heading, at what KIAS should he initiate climb?
• How is route planning assessed in the AMF Checkride?
• What should wingmen do if the flight is climbing and they lose sight of the lead?
• Should autopilot be used during an approach in windshear conditions?
• What is the significance of the Airman Certification Standards (ACS)?
• When can the receiver ascend to the altitude of the tanker during the rendezvous?
• What should be a pilot’s approach to fuel management during the checkride?
• What is required for successful communication with air traffic control during the checkride?
• Airdrop configuration uses how many degrees of flap setting?
• In the context of the AMF Checkride, what is crucial for maintaining control after an engine failure?
• How does rubber reversion occur during Hydroplaning?
• What refers to the distance the wingman must maintain while being out of the lead's jet wash?
• When must the radios and A/A TACAN be set up before the ARCT?
• Why are emergency procedures emphasized in the AMF Checkride?
• What maneuver is commonly demonstrated in the AMF Checkride flight section?
• A simulated airdrop maneuver is performed at a minimum of how many feet AGL?
• What indicates that the formation can switch to departure frequency?
• On the route, the wingman will never fly below lead or which of the following?
• What does the Mean Aerodynamic Chord (MAC) represent in aircraft design?
• Under what circumstances should a pilot conduct an amended preflight briefing?
• Which of the following applies during the cell formation setup with A/P and A/A TACAN?
• What is the minimum KIAS required for a stable airdrop configuration?
• If a wingman loses sight while in a descending turn, what should they do?
• Why is it important for pilots to articulate emergency procedures before the AMF Checkride?
• True or False: Any formation crewmember can call "knock-it-off" if safety of flight is at risk.
• How is reference groundspeed computed?
• What is required knowledge regarding performance charts during the checkride?
• Which situation is NOT a reason to perform a breakout?
• What does ARIP stand for in the context of air refueling?
• What are the main sections of the AMF Checkride?
• What strategies can be utilized for effective engine management during flight?
• Which call sign is used to initiate a breakaway maneuver?
• What is the purpose of the "Breakaway" maneuver?
• Once commencing slowdown, what is the maximum allowable degrees AOB for the lead?
• True or False: Wings should follow lead into IMC conditions.
• How important is crew resource management (CRM) in the AMF Checkride?
• Which of the following describes the contact position?
• During a formation drag, what must the wingman do to ensure proper spacing on landing?
• What is the maximum Zero Fuel Weight in the T-1 aircraft?
• Who is responsible for declaring MARSA during an aerial refueling operation?
• What is the minimum flight time requirement for the AMF Checkride?
• During the formation briefing, what altitude must be briefed for the airdrop?
• What is the significance of situational awareness during the AMF Checkride?
• How do weight and balance affect aircraft performance?
• What defines "Standard Formation" in flight operations?
• What is a characteristic of the legs in a left-hand race track pattern for anchor points?
• Why is situational awareness critical during the checkride?
• Which conditions must be met before MARSA can be declared?
• What defines windshear?
• In swept wing aircraft design, what is needed to determine the MAC?